Understand how the burner has problems (control box)
Time:2014-02-08 Click:
Fault sign: switch on the power supply, the burner doesn't start, the control box lights the trouble light.
Possible causes:
A) may be the fault of the control box.
B) may be burning machine motor can not start, why can not start in addition to motor coil or capacitor motor may be damaged, may also be bearing problems, there may be a combustion engine inlet inhaling fan motor to cause foreign body stuck.
C) may be too tight and the joint bearing oil pump motor does not rotate, this may be due to the fuel pump in the water caused by rust, if it is found that this phenomenon, in addition to solve the problem of oil pump, should also pay attention to the clean fuel, please clean the tank, such as water tank is equipped with valve, please and dirt the release of water at the bottom of the tank. Please note that if the trouble light is lit due to some of the faults in the last operation, the other fault reason shall be considered.
Fault sign: switch on the power supply, the burner doesn't start, but the malfunction light on the control box does not start.
Possible causes:
A) please check the fuse of the power supply, and also see if the thermostat is proper.
B) please check that the control box is securely inserted into the terminal block. Please also check whether the power supply is loose or not.
C) may be the fault of the control box.

New media sharing


WeChat consulting! Close